Synchronously working with heating by dry bath in the bottom and nitrogen blowing on the surface accelerates liquid evaporation and sample concentration.
The position of gas needle in air cavity can be adjusted to suit for different types of tubes.
The height of the air cavity can be adjusted. The length of a standard gas needle is 150mm.
Sample surface in the tube can be observed while concentrating.
Gas needle is controlled independently. Separately blow of each needle and flow regulating of each needle are available to avoid gas waste.
The entire equipment can be put into ventilation cabinet when the concentration sample in toxic solvents.
Built in overheat protection, automatic fault detection and fault beep alarm devices.
LED display immediate temperature and diminishing time. Operation is simple and convenient.
Specification
Model
MSN-200-1B
Temp. Control Range
R.T.+5℃ ~150℃
Temp. Stability@40~100℃
≤±0.5 ℃
Temp. Stability@100~150℃
≤±1℃
Block Temp. Uniformity@100℃
≤±0.5 ℃
Block Temp. Uniformity@150℃
≤±1 ℃
Temp. Display Accuracy
0.1 ℃
Heating Speed
≤30min (40℃ to 150℃)
Time Range
1min~99h59min or continuous
Air cavity Max. Lift Stroke
285mm
Gas-in Joint Outer Diameter
Φ7mm
Nitrogen Pressure
≤0.1MPa
Nitrogen Flow Rate
0 ~10L/min
Needle Length
150mm
Sample Capacity
1 Standard Visible Block
Voltage
AC 220V / AC 110V, 50/60Hz
Power
400W
Fuse
250V, 3A/6A, Ф5×20
Dimension (WxDxH)
220 x 260 x 525mm
Net Weight
5.8kgs
Reviews of Sample Concentrator (visible) MSN-200-1B